Getting the right time to up the nutrients?

MM2K6

Baked
Community Member
User ID
7691
Never been good at adjusting my nutrients, should I be upping my nutrient now? the plants are flowering now :unsure: one tent are auto's and the other photo's running off the same tank (y)
 

Attachments

  • 20260505_153236.jpg
    20260505_153236.jpg
    5.7 MB · Views: 7
  • 20260505_152807.jpg
    20260505_152807.jpg
    5.5 MB · Views: 5
  • 20260505_152908.jpg
    20260505_152908.jpg
    4.2 MB · Views: 5
  • 20260505_153040.jpg
    20260505_153040.jpg
    8.5 MB · Views: 5
  • 20260505_153106.jpg
    20260505_153106.jpg
    7.9 MB · Views: 9
  • 20260505_152709.jpg
    20260505_152709.jpg
    3.5 MB · Views: 7

Please join our community to continue reading

Forgot your password?
Don't have an account? Register now
or

Goonie Goat

Baked
Staff member
Community Member
TSE Mod
User ID
3548
Never been good at adjusting my nutrients, should I be upping my nutrient now? the plants are flowering now :unsure: one tent are auto's and the other photo's running off the same tank (y)
Where they are at now is pretty much red lining with autoflowers I reckon.

Especially those Mango smile x autos, they are pretty sensitive to excessive nitrogen compared to most autos.
 

MM2K6

Baked
Community Member
User ID
7691
Where they are at now is pretty much red lining with autoflowers I reckon.

Especially those Mango smile x autos, they are pretty sensitive to excessive nitrogen compared to most autos.
Do you recon I should run separate tank for the Auto's,? I used to do all photo's :unsure:
 

VinDeezle

Baked
Community Member
User ID
2953
Is there a way you can set the white balance on the camera for a better representation? I had a few lil stick and mango stick autos that were N picky in general and always seemed to be on the back foot a wee bit until they would start to claw once you pushed em. They still developed well.

The cameras auto white balance really made them look worse until I'd take a pic in natural light in the room and they looked like different plants.

I normally stick to an arbitrary EC 2.0 limit when using Coco and either feed more often or look for other uptake issues instead of upping EC.

Have you tried alternating pH between 5.6-5.8 and then back to 6.2 here and there? Some plants just uptake better at lower pH in Coco and you might get a better overall profile of uptake with a bit of swing. I always started to run into chlorosis and rust if I drifted up to 6.5 or above for too long.
 

VinDeezle

Baked
Community Member
User ID
2953
Do you have a way to set the white balance? Set it based off your light or just wing it till it looks normal?
yea just go by what me eye sees haha. The camera always looks so warm in comparison to what I see so I just fucked with it until it looked relatively close to what I see. Would be pretty much the spectrum of the light come to think about it. A mix of 3000k and 6000k diodes (2:1 respectively) with a few reds so close to 4000k.
 

HomeBound_Hound

Baked
Community Member
User ID
455
Never been good at adjusting my nutrients, should I be upping my nutrient now? the plants are flowering now :unsure: one tent are auto's and the other photo's running off the same tank (y)
Assuming that vivosun pen is 500 scale ya running roughly 1.3ec and there's tip burn on a few of em I don't necessarily raise my feed when my auto go to flower I usually just change to flowering feed
 

MM2K6

Baked
Community Member
User ID
7691
Assuming that vivosun pen is 500 scale ya running roughly 1.3ec and there's tip burn on a few of em I don't necessarily raise my feed when my auto go to flower I usually just change to flowering feed
I'm using the same all the way through not grow then bud :unsure: this shit, I'm a cheap ass! :ROFLMAO:


Then in bud
this

And that bud powder from Canada, forgot lol it's in the bag lost the tag !:ROFLMAO::ROFLMAO:

I keep losing shit now I'm older, maybe alzheimer's:unsure::ROFLMAO:
 

VinDeezle

Baked
Community Member
User ID
2953
I'm using the same all the way through not grow then bud :unsure: this shit, I'm a cheap ass! :ROFLMAO:


Then in bud
this

And that bud powder from Canada, forgot lol it's in the bag lost the tag !:ROFLMAO::ROFLMAO:

I keep losing shit now I'm older, maybe alzheimer's:unsure::ROFLMAO:
Mate, I've ran bio Flores and terra Flores (3-1-6 and 2-1-3) all the way through a ton of times aye. Not one to fuck around with different nutes at different times cause I'm a lazy cunt.
 

MM2K6

Baked
Community Member
User ID
7691
Is there a way you can set the white balance on the camera for a better representation? I had a few lil stick and mango stick autos that were N picky in general and always seemed to be on the back foot a wee bit until they would start to claw once you pushed em. They still developed well.

The cameras auto white balance really made them look worse until I'd take a pic in natural light in the room and they looked like different plants.

I normally stick to an arbitrary EC 2.0 limit when using Coco and either feed more often or look for other uptake issues instead of upping EC.

Have you tried alternating pH between 5.6-5.8 and then back to 6.2 here and there? Some plants just uptake better at lower pH in Coco and you might get a better overall profile of uptake with a bit of swing. I always started to run into chlorosis and rust if I drifted up to 6.5 or above for too long.
I'm going to get a camera my shitty A12 :) Mr El-cheapo again! (y)

"Have you tried alternating pH between 5.6-5.8 and then back to 6.2 here and there?"

No I have never dun that, what do you use to drop the PH? and keep the food at the same level? :unsure:
 

MM2K6

Baked
Community Member
User ID
7691
Assuming that vivosun pen is 500 scale ya running roughly 1.3ec and there's tip burn on a few of em I don't necessarily raise my feed when my auto go to flower I usually just change to flowering feed
This my second run of Auto's, always been a photo period Guy (y) I will learn with all the awesome members here, I love this place 💕
 
Top Bottom