- User ID
- 7691
Never been good at adjusting my nutrients, should I be upping my nutrient now? the plants are flowering now
one tent are auto's and the other photo's running off the same tank 
Where they are at now is pretty much red lining with autoflowers I reckon.Never been good at adjusting my nutrients, should I be upping my nutrient now? the plants are flowering nowone tent are auto's and the other photo's running off the same tank
![]()
Do you recon I should run separate tank for the Auto's,? I used to do all photo'sWhere they are at now is pretty much red lining with autoflowers I reckon.
Especially those Mango smile x autos, they are pretty sensitive to excessive nitrogen compared to most autos.
They look fine to me, think your camera just makes them look yellow with the lights on pics. I wouldn't change anythingDo you recon I should run separate tank for the Auto's,? I used to do all photo's![]()
yea just go by what me eye sees haha. The camera always looks so warm in comparison to what I see so I just fucked with it until it looked relatively close to what I see. Would be pretty much the spectrum of the light come to think about it. A mix of 3000k and 6000k diodes (2:1 respectively) with a few reds so close to 4000k.Do you have a way to set the white balance? Set it based off your light or just wing it till it looks normal?
Assuming that vivosun pen is 500 scale ya running roughly 1.3ec and there's tip burn on a few of em I don't necessarily raise my feed when my auto go to flower I usually just change to flowering feedNever been good at adjusting my nutrients, should I be upping my nutrient now? the plants are flowering nowone tent are auto's and the other photo's running off the same tank
![]()
They all seem to be in flower so no need for separate res I don't thinkDo you recon I should run separate tank for the Auto's,? I used to do all photo's![]()
I'm using the same all the way through not grow then budAssuming that vivosun pen is 500 scale ya running roughly 1.3ec and there's tip burn on a few of em I don't necessarily raise my feed when my auto go to flower I usually just change to flowering feed
I assumed the vivo meter was pH. 830ppm would be around EC 1.66.Assuming that vivosun pen is 500 scale ya running roughly 1.3ec and there's tip burn on a few of em I don't necessarily raise my feed when my auto go to flower I usually just change to flowering feed
Mate, I've ran bio Flores and terra Flores (3-1-6 and 2-1-3) all the way through a ton of times aye. Not one to fuck around with different nutes at different times cause I'm a lazy cunt.I'm using the same all the way through not grow then budthis shit, I'm a cheap ass!
![]()
Hydroponic Nutrients Hydroponic Plant Grow and Bloom A & B set indoor / outdoor | eBay Australia
Complete Grow hydroponic nutrients is suited for all hydroponic systems. SO YOU GET THE BEST NUTRIENTS YOUR PLANT NEEDS. coco coir, rockwool, soil and potted plants.www.ebay.com.au
Then in bud
this
And that bud powder from Canada, forgot lol it's in the bag lost the tag !
I keep losing shit now I'm older, maybe alzheimer's![]()
True very true 0.8x2 does equal 1.6 lmfaoI assumed the vivo meter was pH. 830ppm would be around EC 1.66.
Bunnings peat and perliteWhat media are you growing in again MM2K6
I'm going to get a camera my shitty A12Is there a way you can set the white balance on the camera for a better representation? I had a few lil stick and mango stick autos that were N picky in general and always seemed to be on the back foot a wee bit until they would start to claw once you pushed em. They still developed well.
The cameras auto white balance really made them look worse until I'd take a pic in natural light in the room and they looked like different plants.
I normally stick to an arbitrary EC 2.0 limit when using Coco and either feed more often or look for other uptake issues instead of upping EC.
Have you tried alternating pH between 5.6-5.8 and then back to 6.2 here and there? Some plants just uptake better at lower pH in Coco and you might get a better overall profile of uptake with a bit of swing. I always started to run into chlorosis and rust if I drifted up to 6.5 or above for too long.
This my second run of Auto's, always been a photo period GuyAssuming that vivosun pen is 500 scale ya running roughly 1.3ec and there's tip burn on a few of em I don't necessarily raise my feed when my auto go to flower I usually just change to flowering feed
Most my runs r autos I do photos but autos r my favouritesThis my second run of Auto's, always been a photo period GuyI will learn with all the awesome members here, I love this place
![]()