Show your setup

[Red Eye Hero]

Hey guys just wanted to see everyone’s different set up’s and how they look and what you’re running most of you have already seen mine though my other thread
But here it is again
So I’m running 4 30L buckets connected to 130L Reservoir, Mars hydro TS 3000 led Ac infinity humidity and temperature control with carbon filter two small fans and one big 400mm fan which is yet to be mounted in the red circle also have pulse one grow monitor coming and teco hy water chiller
Don’t forget to share your systems and set up

 

[Madmick]

Where's the plants?

 

[Red Eye Hero]

Where's the plants?

Soon as I move I’ll be growing

 

[Red Eye Hero]

Lol any one going to comment there setup or just like the post

 

[Sedge]

Look in the grow diaries ,,

 

[puggle6]

Lol any one going to comment there setup or just like the post

I've been meaning to get to construction of mine, I'll post it up when I get around to it.

Basically it is a full room about 3.5x2.5m with a 860w CMH and a total of 1000w strip lighting around the perimeter

 

[Porky]

Yeah plenty of pics of my setup in my grow diary.

 

[Ooodog]

This is my setup. It evolves constantly hopefully leading to a better environment.
My propagation/clone tent/area.


It consists of a seahawk small tent, a seahawk heating mat, a t5 twin Fluro light, a 4 inch fan for air circulation, a seedling enclosure(Bunnings) and a cheap temp/humidity monitor.
When I started I thought I could do it all with just my main led and tent. It worked but I basically doubled my veg time doing it that way. The little tent is a ripper. Performed very well in the middle of winter.

My main tent.

1.2x1.2x2.0 metres. It’s the next major item I plan to replace.

My intake is a small 4inch carbon filter being drawn by another 4inch fan.


Exhaust is a 6inch hyper fan pulling thru a 150x500 mm phresh carbon filter. If I had my time again I would go with either an 8inch fan and filter combo or try a different brand.
It works great but when running at 100% it is very loud. Normally I have it at 35% but crank it up when the tent is open.
The black flood table is a new addition so I haven’t any feedback yet.

You can just see the air filter behind the light.
My light is a 315w cmh from Hi-par. It’s the sunstorm product with everything included. Only finished one grow with it and I’m very happy how that finished.
It gives me the option of storing the ballast outside the tent to minimise excessive heat during summer.

I have a few fans that I swap in and out as the situation dictates. At the moment I have one stationary 150mm fan and 2 fan towers.
It is a run to waste system that I hand water and use a wet/dry vacuum to empty the flood table with.
I hope this is what you were after. I tried doing everything on the cheap but it just made my life difficult. Good equipment is vital.

 

[Dotts]

Nice set up Ooodog! im pretty much the same except

2x2x2 tent, sol-sence 315cmh n chuck n a 400hps for flower

in a Hipar Duel cmh/hps air cooled reflector,

same Phresh Fliters, same Hyper Fan except all 8 inch fittings n acoustic ducting slowed down

with a decient Varaic speed fan controller, very similar Flood table aswell

Great minds think alike